天津威磊电子技术有限公司

首页:登陆:注册:精华:排行版主

讨论区方式查看

界面风格：

ATMEGA88 fuse bit

inkub

If RSTDISBL is set "0" then ATMEGA not read, erase.
SPI is block.
Need parallel programmer.
I need help with this problem.

regards

返回列表

[ 发表时间：2008-07-03 03:46:35 ]

Re:ATMEGA88 fuse bit

This is the chip function itself.Once the RSTDISBL is set "0" ,then ATMEGA not read, erase.It must be programmed by parallel mode,the chip can resume.There is not any other way.

返回列表

[ 发表时间：2008-07-03 09:02:09 ]

Re:ATMEGA88 fuse bit

inkub

Yes, but if you add programming for parallel VP980?

返回列表

[ 发表时间：2008-07-03 14:25:55 ]

Re:ATMEGA88 fuse bit

Once the RSTDISBL is set "0"by ISP mode,the chip didn"t be read, erase by ISP mode.It must be erased by parallel mode,the chip can resume.In the parallel mode,there are many pin to be used.After the chip resuming,the chip can be programmed by ISP mode again.There is not any other way.VP-980 can support parallel mode to programme this chip.In the chip list,the chips,there is not brackets(ISP) behind the chips name,is parallel mode.

返回列表

[ 发表时间：2008-07-03 15:50:27 ]

Re:ATMEGA88 fuse bit

inkub

"VP-980 can support parallel mode to programme this chip"

Maybe add support for serial programming ATMEGA88 ?

返回列表

[ 发表时间：2008-07-03 16:49:14 ]

Re:ATMEGA88 fuse bit

VP-980 can support two programmer mode,one is parallel mode,the other is ISP series mode.The pin that parallel mode is different from the pin that series mode.So,you must rejigger the RSTDISBL "1" by parallerl mode.

返回列表

[ 发表时间：2008-07-07 09:00:53 ]

共有回复 5 个，共 1 页